SmartBMS UtilityConfiguration
Take charge of your battery management system — tune it to your setup, not a factory default.
Personalized settings
Set charge and discharge parameters, safety limits, total battery and cycle capacity, cell self-discharge rate, and full cell voltage thresholds to match your pack, not a generic default.
Battery life preservation
Calibrate charge cycles and discharge thresholds to reduce wear, extend usable life, and cut down on maintenance surprises.
Profiles you can share
Save a configuration as a profile, export it, and share it with dealers or fellow off-gridders running the same hardware — or import theirs.
No laptop required
Everything that used to need a serial cable now happens from your phone.
Low technical bar
A guided interface built so configuring a BMS doesn't require reading a datasheet first.
Save & restore
Keep known-good configurations on hand and roll back instantly if something changes.
What you can configure
- ▸Device name, barcode & number of cells
- ▸Total battery & cycle capacity (mAh)
- ▸Cell self-discharge rate (%) and cell full voltage (mV)
- ▸Separate BMS and Bluetooth passwords
- ▸Notification triggers, per device
- ▸Voltage, current & temperature calibration
- ▸Logging on/off, with adjustable interval
- ▸BMS heating on/off, where supported